KEYENCE LJ-H1W - Manual (Page 18)

Connecting via USB
1-14 LJ-H1W-M-NO1-E
The driver is installed at the same time as the application software for Windows 7, Vista, XP, and 2000. Normally
following operations are not necessary. If the driver installation is cancelled while installing the application
software, follow the procedure to install the USB driver that is described below.
Installing on Windows XP
Connect the controller to a computer with Windows XP. If the controller is being connected for the first time, the
USB driver for the LJ-G Series must be installed. The connection is automatically recognized after the USB driver
has been installed once and does not need to be installed again.
This section explains how to installed the driver for the LJ-G Series when first connecting to a computer with
Windows XP.
Hardware detection must be performed when installing the USB driver for the LJ-G Series.
Use the following methods to install the driver.
1
Start up Windows XP and log in as a user that has Administrator privileges (or similar privileges that
permit changing system settings).
2
Connect the USB port on the computer with the USB port on the LJ-G Series controller with the USB
cable.
The message "Found New Hardware" appears and the Hardware Update Wizard starts up.
3
Select [Install from a list or specific location (Advanced)], and click the [Next] button.
Installing the USB Driver