KEYENCE LJ-H1W - Manual (Page 21)

Connecting via Ethernet
1-17
Getting St
a
rted
1
LJ-H1W-M-NO1-E
Set the following communication settings when communicating with Ethernet.
IP address Configure unique addresses for the computer and each controller.
Ex.: When using two controllers and one computer
Controller No. 1 192.168.0.10
Controller No. 2 192.168.0.11
Computer 192.168.0.12
Subnet mask Configure the same settings on the computer and controllers. Use the default
value normally.
(Default: 255.255.255.0)
Default gateway Use the default value normally. (Default: 0.0.0.0)
1
Set the Ethernet settings for the controller.
Set the IP address, subnet mask, and default gateway.
For more information about configuring settings, see "LJ-G Series User's Manual".
Note
Restart all of the controllers after configuring the settings to activate the changes to the Ethernet settings.
2
Set the Ethernet settings (TCP/IP) for the computer.
The method for configuring the settings depends on the version of Windows. For more details, see the
instruction manual for the computer or LAN card.
3
Start up LJ-Navigator.
"Starting and Exiting LJ-Navigator" (Page 1-5)
4
Select [PC communication setting] from the [Comm settings] menu.
The [Comm settings] dialog appears.
Configuring Communication Settings