KEYENCE LJ-H1W - Manual (Page 94)

Error Message List
Appendix-10 LJ-H1W-M-NOA-E
Head setting The value for delay count exceeds the
setting range.
Set the value between ( ) and ( ).
* The values displayed within the
parentheses ( ) vary depending on the
sampling count.
Set the delay count between 0 and 99,
depending on the sampling count. Page 5-3
The maximum value for Manual exceeds the
setting range.
Set the value between 1 and 99. Set the maximum value for Manual of the
laser intensity between 1 and 99. Page 5-3
The minimum value for Manual exceeds
the setting range.
Set the value between ( ) and ( ).
* The values displayed within the
parentheses ( ) vary depending on the
maximum value for Manual.
Set the minimum value for Manual of the
laser intensity between 1 and 99 and below
the maximum value for Manual of the laser
intensity. Page 5-3
The number of times for profile alarm
exceeds the setting range.
Set the value between 0 and 255. Set the number of times for profile alarm
between 0 and 255. Page 5-3
The value for correction angle exceeds the
setting range.
Set the value between -10
° and 10 ° .
Set the correction angle between -10 ° and
10 ° .
Page 5-3
The value for height correction exceeds
the setting range.
Set the value between 0 and 10. Set the height correction between 0x and
10x. Page 5-3
Profile setup The amount of movement in the X direction
exceeds the range. Set the amount of movement in the X direction
within the range for X measurement width. Page 5-5
The amount of movement in the Z direction
exceeds the range. Set the amount of movement in the Z
direction within the range for Z measurement
width. Page 5-5
The value for delay count between the
heads exceeds the setting range.
Set the value between 0 and 1023. Set the value for delay count between the
heads between 0 and 1023. Page 5-5
Failed to acquire profile for Head A. • Check whether communication is possible
between the controller and computer.
• Set the controller to "Measurement
screen (Measuring)".
Pages 4-7,
5-5
Failed to acquire profile for Head B. • Check whether communication is possible
between the controller and computer.
• Set the controller to "Measurement
screen (Measuring)".
Pages 4-7,
5-5
Master
registration Failed to acquire profile for Head A. • Check whether communication is possible
between the controller and computer.
• Set the controller to "Measurement
screen (Measuring)".
Pages 4-7,
5-5
Failed to acquire profile for Head B. • Check whether communication is possible
between the controller and computer.
• Set the controller to "Measurement
screen (Measuring)".
Pages 4-7,
5-5
Item Error message Measure Reference