KEYENCE LJ-H1W - Manual (Page 73)

Settings
5-9
Setting E
a
ch F
u
nction
5
LJ-H1W-M-NO5-E
Measurement conditions
The measurement conditions can be set in the following range.
Minimum display unit
The minimum display unit can be set in the following range.
* 0.1 μm is displayed only when LJ-Navigator receives the settings from the controller to which the LJ-G015 or LJ-G015K are
connected, or when the default startup file for the LJ-G015 or LJ-G015K is selected before startup.
Tolerance settings
The tolerance settings can be set in the following range.
Settings Setting range Initial value
Average measurement 1/2/4/8/16/32/64/128/256/512/1024/2048/4096 1
Measurement alarm 0 to 255 0
Measurement mode Normal/Peak hold 1/Bottom hold 1/
Peak-to-peak hold 1/Average hold 1/
Peak hold 2/Bottom hold 2/Peak-to-peak hold 2/
Average hold 2/Sample hold
Normal
Offset 0.000 to 999.999 0.000
Settings Setting range Initial value
Min display unit 1 mm/0.1 mm/0.01 mm/0.001 mm/1 μm/0.1 μm
*
0.001 mm
Settings Setting range Initial value
Tol upper limit -999.999 to 999.999 5.000
Tol lower limit -999.999 to 999.999 -5.000