KEYENCE LJ-H1W - Manual (Page 62)

Profile Storage
4-24 LJ-H1W-M-NO4-E
Starting profile storage
1
Connect LJ-Navigator and the controller, check that communication can be established, and then
measure the measurement target.
"Connecting via USB" (Page 1-12)
"Connecting via Ethernet" (Page 1-16)
"Connecting via RS-232C" (Page 1-19)
2
Set the storage settings to [Profile storage] in the common settings for the controller.
3
Click the [Profile storage] icon of the tool bar.
The [Profile storage] window appears.
4
Click the [Start storage] button.
The controller starts storing the profile.
When the number of stored profiles matches the value set for [No. of profiles] in the [Profile storage settings]
dialog box, the storage stops automatically.
Reference
• The storage timing depends on the trigger settings and data output timing settings. Data can be stored at a specified timing
when performing continuous storage. If you want to stop the data storage in the middle of storage, click the [Stop storage]
button.
• If communication is not possible between LJ-Navigator and the controller, or if a head is not connected, the following dialog
appears shortly after clicking the [Start storage] button or the [Read storage data] button.
Check the connection between each head and between LJ-Navigator and the controller. Check that the controller is set to
[Profile storage].