KEYENCE LJ-H1W - Manual (Page 51)

Data Storage
4-13
Di
s
pl
a
ying the
Me
asu
rement D
a
ta
4
LJ-H1W-M-NO4-E
(3)[Clear storage data] button
Clears all of the measurement data from all of the OUT settings that are stored in the internal memory of the
controller.
(4)[Data storage] button
Displays the [Data storage] dialog box.
This dialog box can be used to configure the controller’s data storage settings.
(5)[Read storage data] button
Reads the data that is stored in the connected controller on LJ-Navigator.
(6)Amount of storage data
Displays the amount of data that is stored on the controller.
(7)Current status
Displays the current operation status for the controller.
Amt of data Sets the amount of data points to store.
Setting range: 1 to 65536
Skipping Sets the number of points to skip from the stored data points.
Setting range: 1/2/5/10/20/50/100
All reception Receives all of the storage settings (program Nos. 0 to 15 and environment settings)
from the controller.
Single reception Receives the storage settings from a single, selected program No.
All transmission Sends all of the storage settings (program Nos. 0 to 15 and environment settings)
from LJ-Navigator to the controller.
Single sending Sends the storage settings from a single, selected program No.
Close Closes the [Data storage] dialog box.