A&D Weighing BM-20 - Manual (Page 45)

BM series 43
Class Item and Parameter Description
off No limit t-Up
Timeout
on 1 second
Selects the wait time to receive
a command.
off No output
5if
Serial
interface
erCd
AK, Error code
on Output
AK: ASCII code 06h
0 Water temperature
d5 fnc
Density
function
ldin
Liquid density input 1 Liquid density Available only when density
mode is selected
Unit
Unit
Refer to " 5. Weighing Units".
C5 in
Internal mass correction
Displayed only when the internal mass value correction
switch is set to 1. Refer to " 8. Calibration (To Adjust The
Weighing Value)".
id
ID number setting
Refer to " 11. ID Number And GLP Report".
0 3 seconds
1 10 seconds
ion
Neutralization time
2 Manual operation (max. 10 min.)
Refer to " 6.5. Built-in DC
Static Eliminator" ".
off The ION key is not used. 8922
AD8922 control
on Applies the ION key to the MODE key on AD-8922.
0 Applies the PRINT key and RE-ZERO key.
1 Applies the
PRINT key and ION key.
ionfnc
Static
eliminator
e-5
External control input
2 Applies the
ION key and RE-ZERO key.
off No used
door
Door state
function
d-dt
Door sensor
on Used
: Factory settings.
10.3. Description Of The Class "Environment, Display"
Condition ( Cond )
Cond 0 This parameter is for sensitive response to the fluctuation of a mass value. Used for
powder target mass, weighing a very light sample or when quick response weighing is
required. After setting, the balance displays
FAST .
Cond 2 This parameter is for stable weighing with slow response. Used to prevent a mass
value from drifting due to vibration or drafts. After setting, the balance displays SLOW .
Notes In automatic response adjustment, this parameter is selected automatically.
Stability band width ( 5t-b )
This item controls the width to regard a mass value as a stable value. When the fluctuation per
second is less than the parameter, the balance displays the stabilization indicator and outputs or
stores the data. The parameter influences the "Auto print mode".
5t-b 0 This parameter is used for sensitive response of the stabilization indicator. Used for
exact weighing.
5t-b 2 This parameter ignores slight fluctuations of a mass value. Used to prevent a mass
value from drifting due to vibration or drafts.