A&D Weighing BM-20 - Manual (Page 49)

BM series 47
MT format 5if type 3
A header of two characters indicates the balance condition.
The polarity sign is used only for negative data.
The weighing data uses spaces in place of the leading zeros.
The character length of this format changes dependent upon the unit
NU (numerical) format 5if type 4
This format outputs only numerical data.
This format consists of ten characters excluding the terminator.
The polarity sign is placed before the data with the leading zeros. If the data is zero, the plus sign
is used.
CSV format 5if type 5
This format separates the data of A&D standard format and the unit by a comma ( , ).
This format outputs the unit even when the data is overloaded.
When a comma ( , ) is selected for the decimal point, the separators are set to semicolon ( ; ).
When the ID number, data number, time and date are added at "Data output (
dout )" of the
function table, outputs ID number, data number, date, time and weighing data in this order and
separates each item by a comma and treats all the items as one group of data.
ID number dout 5-id 1
The number to identify a specific balance.
This format consists of eight characters excluding the terminator.
Data number dout d-no 1
This format outputs the data number just before the data is transmitted using the RS-232C
interface.
This format consists of six characters excluding the terminator.
When CSV format (
5if type 5 ) is selected, the period ( . ) is replaced with a comma ( , ).
Data number Terminator
ID number Data number Date Time Weighing data
Stable header
Unstable header
Overload header
Header Data Unit Terminator
Data Terminator