Interlogix Concord Express Installation Manual - Manual (Page 42)

Chapter 2
36 Concord Express Installation Instructions
Auto Stay Arming (0014) Security-Partition 1 (Default =
on)
This setting determines whether or not the system
automatically arms to STAY (level 2) if the user arms the
system to AWAY (level 3) without exiting the premises. This
can help prevent accidental alarms by deactivating interior
motion sensors during occupied arming periods.
Note : Arming the system to AWAY with No Delay overrides
the Auto Stay Arming feature.
With the feature turned on, the user arms the system to
AWAY. Touchpads (and other status sounders) emit one exit
delay beep every four seconds, then one every second during
the last 10 seconds. If the exit delay time expires with no
standard delay sensor activation, the system automatically
arms to STAY.
To turn Auto Stay Arming off
or on:
1. With the display showing
AUTO STAY ARMING OFF/ON
(current setting), press 1 (off)
or 2 (on). The display flashes
the entered setting.
2. Press # and the display
shows the new setting.
Keyswitch Sensor (0015) Security-Partition 1 (Default =
none)
This feature lets users arm and disarm the system using
either a keyswitch wired to a hardwire zone input or a
wireless door or window sensor.
For example, if sensor 1 is designated as the keyswitch
sensor and the system is disarmed, then tripping sensor 1
arms the system to AWAY. If the system is armed to STAY
or AWAY, tripping sensor 1 disarms the system. The panel
reports opening, closing, and force armed reports (if these
features are turned on) to the central monitoring station.
Note: A bypassed keyswitch sensor cannot arm or disarm
the system.
During an audible alarm, keyswitch sensors can disarm the
system (which sends a cancel report to the central
monitoring station), but cannot arm the system. The system
can be armed only after siren timeout expires.
Keyswitch sensors test the same as any other sensor and
do not arm or disarm the system during a sensor test.
To assign a Keyswitch Sensor:
1. With the display showing
KEYSWITCH SENSOR n
(current
sensor number), enter the
desired sensor number (01-24).
The display flashes the entered
sensor number.
2. Press # and the display shows
the new number.