Interlogix Concord Express Installation Manual - Manual (Page 55)

Chapter 2
Concord Express Installation Instructions 49
Police Panic (0402) Touchpad Options-Partition 1 (Default=on)
This setting determines whether
touchpad police panic buttons are
enabled (on) or disabled (off) on. To change the Police Panic setting:
1. With the display showing
POLICE PANIC OFF/ON
(current setting), press 1 (off) or 2 (on). The
display flashes the entered setting.
2. Press # and the display shows the new setting.
Keychain TP Arm (0403) Touchpad Options-Partition 1 (Default=off)
This setting determines how the keychain
touchpad arms the system. When set to
ON, pressing the
LOCK button arms the
system directly to AWAY with no Entry
and Exit Delay. When set to OFF,
pressing the
LOCK button increments the
arming level from OFF to STAY and from
STAY to AWAY.
To change the Keychain Touchpad Arming
setting:
1. With the display showing KEYCHAIN
TOUCHPAD ARM OFF/ON (current setting),
press 1 (off) or 2 (on). The display flashes the
entered setting.
2. Press # and the display shows the new setting.
Star Is No Delay (0404) Touchpad Options-Partition 1 (Default=off)
This setting determines whether the
keychain touchpad star button controls an
onboard or SnapCard output (off) or the
No Delay feature (on). To change the Keychain Star Is No Delay setting:
1. With the display showing STAR IS NO DELAY
OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press # and the display shows the new setting.
Reporting Menu
The REPORTING menu lets you set up which system events (global or partition)
are reported to the central monitoring station. The following describes how to
program the reporting settings that appear under GLOBAL.
24-Hour Tamper (05000) Reporting-Global (Default=off)
When this feature is turned on, the panel
sounds sirens and reports a tamper alarm
when wireless sensor tamper switches
are activated (even when the system is
disarmed). To turn 24-Hour Tamper off or on:
1. With the display showing 24-HOUR TAMPER
OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press # and the display shows the new setting.