Interlogix Concord Express Installation Manual - Manual (Page 50)

Chapter 2
44 Concord Express Installation Instructions
Cancel Message (02007) Phones Options-Global (Default=on)
This setting determines whether or not the
panel displays a cancel message after the
user disarms the system to clear an alarm
condition. To turn Cancel Message off or on:
1. With the display showing CANCEL
MESSAGE OFF/ON (current setting), press 1
(off) or 2 (on). The display flashes the entered
setting.
2. Press # and the display shows the new
setting.
Pager Delay (02008) Phones Options-Global (Default=15 sec.)
This setting determines how long a report is
delayed to a pager (00-30 seconds) after the
panel dials the pager number.
Note : The Pager Delay time should not be
set below 5 seconds unless absolutely
necessary.
To set the Pager Delay time:
1. With the display showing
PAGER DELAY nn
(current setting), enter a two-digit time (00-
30). The display flashes the entered setting.
2. Press É and the display shows the new
setting.
Call Wait Cancel (02009) Phones Options-Global
(Default=none)
This feature lets you set up a dialing prefix to disable the call
waiting feature before the panel makes its first dialing attempt to
any programmed central monitoring station, pager, or downloader
phone number. The prefix can be up to eight digits. For prefixes
that require dialing * or #, press and hold for two seconds 7 (for *)
or 9 (for #).
Caution : DO NOT change this option from its default if the
customer doesn’t have call waiting. Verify with the customer that
they have call waiting with their phone service provider before
changing this option from its default. Changing this option from its
default without call waiting will prohibit the panel from calling the
central station.
To set up Call Wait Cancel:
1. With the display showing
CALL WAIT CANCEL __
(or
current setting), enter the
desired prefix. The
display flashes the
entered setting.
2. Press # and the display
shows the new setting.
The following describes how to program the PHONE OPTION settings that
appear under PARTITION 1.
Remote Access (0210) Phones Options-Partition 1 (Default=on)
This setting determines whether or not the
panel can be accessed from off-site for
downloader programming. To turn Remote Access off or on:
1. With the display showing
REMOTE ACCESS
OFF/ON
(current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press # and the display shows the new setting.