TeeJet Matrix Pro 840G User Manual - Manual (Page 101)

94
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
GUidEliNES
Curved Lookahead indicates what direction the vehicle will take when steering in any given direction.
AB guidelines, Azimuth guidelines, next pass guidelines and NextRow guidelines are each available depending on the current guidance
mode. Up to 25 established guidelines are stored in the console per job. Switching from one guidance mode to another will change the
current available guidelines.
Multiple guidelines can be created in each guidance mode. If more than one guideline is saved in a single guidance mode, the Next Guideline
feature will become available. By pressing the Next Guideline option, the vehicle will be directed to the next guideline saved in
the console.
A user can duplicate and edit jobs for reuse of boundaries and guidelines for different applications over the same field using Fieldware Link or
the Data->Manage Data option.
Curved lookahead Guideline
The curved lookahead guideline provides an indication of where the
current steering will take the vehicle using a ‘pointer’ as guidance.
The Curved Lookahead option is available in all guidance modes.
To activate the Curved Lookahead guideline:
1. Press NAVIGATION AND GUIDANCE OPTIONS icon to
display navigation options.
2. Select CURVED LOOKAHEAD icon
The pointer will be visible on the navigation screen.
Figure 7-22: Curved Lookahead
-13 7.2 mph
Mark A
To remove the Curved Lookahead guideline:
1. Press NAVIGATION AND GUIDANCE OPTIONS icon to
display navigation options.
2. Select CURVED LOOKAHEAD icon
Straight ab Guidelines
Straight AB guidance provides straight line guidance based on
A and B reference points. The original A and B points are used to
calculate all other parallel guidelines based on the programmed
guidance width.
Marking A and B Points
To establish an AB guideline:
1. Drive to the desired location of Point A .
2. Press NAVIGATION AND GUIDANCE OPTIONS icon to
display navigation options.
3. While the vehicle is in motion, press MARK A icon A .
4. Drive to the desired location of Point B .
5. Press MARK B icon
B to establish the AB line.
6. “Would you like to name this guideline?”
Press:
►Yes – to enter a name and save the guideline in the console
►No – to automatically generate a name and save the guideline
in the console
The console will begin providing navigation information.
NOTE: The MARK B icon
B
is not available for selection
(greyed out) until the minimum distance is travelled
(9.84 feet / 3.0 meter).
Use CANCEL MARK icon to cancel the Mark A command and
revert to the previous straight AB guideline (when established).
To establish additional straight AB guidelines, follow the same steps
as the initial straight AB guideline. To toggle between straight AB
guidelines, see “Next Straight AB Guideline Feature”.