TeeJet Matrix Pro 840G User Manual - Manual (Page 114)

107
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
Single Section
If a SmartCable or Section Driver Module (SDM) is not present,
BoomPilot is used to turn all booms on or off. BoomPilot can be
overridden by using the Work On/Off Switch. Only one Boom Section
width will be illustrated and the Status Bar will have no icon.
NOTE: GPS is unavailable when the BOOMPILOT icon is grey .
If a SmartCable or Section Driver Module (SDM) is present,
please refer to SmartCable or SDM Section for more
information.
To switch application off or on using the console:
1. Work On/Off Switch should remain in the “Off” position.
2. Press NAVIGATION AND GUIDANCE OPTIONS icon to
display navigation options.
3. Press BOOMPILOT icon .
NOTE: If the Work On/Off Switch is in the “On” position,
the entire section will be activate and the
BOOMPILOT icon will have no affect.
If the Work On/Off Switch is not present on the system, the
BOOMPILOT icon will controll the application on/off
functions.
In areas where application is not desired:
◄Press BOOMPILOT icon . Press the BOOMPILOT icon
again to reseume application.
◄Turn the Work On/Off Switch to the “On” position and back to
the “Off” position. Turn the Work On/Off Switch “on” to resume
application.
Figure 7-63: All Booms Off/On – No SDM
7.0 km/h 0.02 ac
Mark A
0.0 mph 0.00 ac
Mark A
A A
ZOOM iN/OUT
vehicle view
Zoom In/Out & Perspective is used to adjust the vehicle’s view or
perspective to the horizon from vehicle view to bird’s eye view.
• Zoom in will adjust view to vehicle view displaying a
compass on the horizon
• Zoom out will adjust view to bird’s eye view
Figure 7-64: Zoom In to Zoom Out
-13 7.2 mph
Mark A
-13 7.2 mph
Mark A