TeeJet Matrix Pro 840G User Manual - Manual (Page 60)

53
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
tilt
The Tilt function corrects the GPS signal to compensate for errors in
the GPS position while operating on sloped terrain.
NOTE: A mistake in the calibration process that results in a 1
degree error in the Tilt reading from the SCM/TGM will
result in a 2.0 in. / 5.1 cm error in guidance [on a machine
that has 9.5 ft. / 2.9 m antenna height]. This potential error
necessitates that all reasonable care is taken to ensure that
the system is installed and calibrated correctly in order to
produce accurate Tilt measurement and machine guidance.
1. Press CONFIGURATION side tab .
2. Press
Tilt
.
3. Select from:
►Enabled – used to set tilt correction to on or off
►Field Level – used to calibrate tilt correction
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.
NOTE: If FieldPilot or UniPilot is being used, tilt correction is built
into the SCM.
NOTE: Antenna Height must be entered prior to Tilt Calibration.
Figure 6-44: Tilt
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config-> Tilt
Field level
Enabled On
Tilt Correction Unavailable
If a TGM or SCM is not connected or the vehicle is in motion,
calibration option will not be available. Vehicle must be stopped for at
least 10 seconds to begin to calibrate tilt correction.
Enable/Disable Tilt
Set Tilt option to on or off.
1. Press DOWN arrow to access the list of options.
2. Select:
►On
►Off
NOTE: When tilt is enabled and the vehicle is in motion,
Field Level
will not be available. Vehicle must be stopped for at least
10 seconds to begin to calibrate tilt correction.
Figure 6-45: Tilt On/Off
Config-> Tilt
Field level
Enabled On
On
Off
Config-> Tilt
Field level
Enabled On
If Enabled is set to “Off”, field leveling capabilities will be
disabled (option will be grayed out).
Figure 6-46: Tilt Correction Off
Config-> Tilt
Field level
Enabled Off