TeeJet Matrix Pro 840G User Manual - Manual (Page 62)

55
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
lightbar
Lightbar Setup is used to configure LED Brightness, Display/Swath Mode and LED Spacing.
1. Press CONFIGURATION side tab .
2. Press
Lightbar .
3. Select from:
►Brightness – used to select the brightness of the lightbar LEDs
►Display Mode – used to select whether the lightbar represents the swath or vehicle
►LED Spacing – used to set the distance illustrated by the illuminated LEDs
Press RETURN arrow or CONFIGURATION side tab to return to the main Configuration screen.
Figure 6-48: Lightbar
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config-> lightbar
brightness
Mode
lEd Spacing 3,50 m
Swath
50%
LED Brightness
LED Brightness adjusts the brightness of the lightbar LEDs. Range is 0 - 100.
1. Press:
►UP arrow to brighten the LEDs
►DOWN arrow to darken the LEDs
Figure 6-49: LED Brightness
Config-> lightbar
brightness
Mode
lEd Spacing 3,50 m
Swath
50%