TeeJet Matrix Pro 840G User Manual - Manual (Page 104)

97
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
Figure 7-31: Save Guideline
1:15 PM 7.2 mph
> 0.0 <
would you like to name this guideline?
Yes No
1:14 PM 7.2 mph
> 0.0 <
Enter Name
1 5 9 2 6 0 3 7 4 8
q
Caps
Alt
t
f
v
o
k
Shift
w
a
z
y
g
b
p
l
e
s
x
u
h
n
r
d
c
i
j
m
<---
Figure 7-32: Follow Guidance
0 deg 7.2 mph
> 0.0 <
Curved ab Guidelines
Curved AB Guidance provides guidance along curved lines based on
an initial AB reference line. This initial baseline is used to calculate
all other guidelines based on the programmed guidance width.
Marking A and B Points
To establish an AB guideline:
1. Drive to the desired location of Point A .
2. Press NAVIGATION AND GUIDANCE OPTIONS icon to
display navigation options.
3. While the vehicle is in motion, press MARK A icon A .
4. Following the path of the intended reference line, drive to the
desired location of Point B .
5. Press MARK B icon B to establish the AB line.
6. “Would you like to name this guideline?”
Press:
►Yes – to enter a name and save the guideline in the console
►No – to automatically generate a name and save the guideline
in the console
The console will begin providing navigation information.
NOTE: The MARK B icon
B
is not available for selection
(greyed out) until the minimum distance is travelled
(9.84 feet / 3.0 meter).
Use CANCEL MARK icon to cancel the Mark A command and
revert to the previous curved AB guideline (when established).
To establish additional curved AB guidelines, follow the same steps
as the initial curved AB guideline. To toggle between curved AB
guidelines, see “Next Curved AB Guideline Feature”.
Figure 7-33: Mark A Point
1:12 PM 7.2 mph
Mark A
A