TeeJet Matrix Pro 840G User Manual - Manual (Page 44)

37
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
implement - Single boom Setup
Implement Setup for a single boom is used to establish guidance
width and spray width.
Note: If a SmartCable or Section Driver Module (SDM) is present
the configurations for Number of Boom Sections, Overlap,
Delay On and Delay Off will be available. Please refer to the
Implement - SmartCable or SDM section to view setup steps.
1. Press CONFIGURATION side tab .
2. Press
Implement
.
3. Select from:
►Guidance Width – used to enter the width between the
guidelines
►Spray Width – used to enter the width of the implement
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.
Figure 6-19: Implement Setup Options with No SDM
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config->implement
Num Sections
Spray width
Guidance width 60.00 ft
12.00 ft
1
Guidance Width
Guidance Width establishes the width between the guidelines.
Range is 3.28 - 246.1 feet / 1.0 - 75.0 meters.
1. Press the KEYPAD icon
.
2. Use the entry screen to establish the guidance width.
NOTE: This setting is required for auto steering and tilt sensor
operation.
Figure 6-20: Guidance Width
Config->implement
Num Sections
Spray width
Guidance width 60.00 ft
12.00 ft
1
Guidance width (ft)
1 2 3
60.00
Clear
4 5 6 <--
7 8 9
0 . +/-
Spray Width
Spray Width establishes the width of the implement.
Range is 3.28 feet (39.3701 inches) - 246.06 feet (2952.76 inches) /
1.0 - 75.0 meters.
1. Press the KEYPAD icon
.
2. Use the entry screen to establish the spray width.
NOTE: This setting is required for auto steering and tilt sensor
operation.
Figure 6-21: Spray Width
Config->implement
Num Sections
Spray width
Guidance width 60.00 ft
12.00 ft
1
Section 1 width (in)
1 2 3
12.00
Clear
4 5 6 <--
7 8 9
0 . +/-