TeeJet Matrix Pro 840G User Manual - Manual (Page 28)

21
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
Vehicle Setup
1. Press CONFIGURATION side tab .
2. Press
Vehicle
.
3. Select from:
►Vehicle Type – selects the type of vehicle that most closely
represents your vehicle
►Antenna Height – sets the height of the antenna from the
ground
►Direction to Boom – sets whether the boom is located
behind or in front of the GPS antenna
►Distance to Boom – defines the distance from the GPS
antenna to the boom
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.
Figure 3-16: Vehicle Setup Options
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config-> Vehicle
Vehicle Type
Ant Height
dir to boom
dist to boom
12.50 ft
0.00 ft
Front wheel
backward
AutoSteer Setup
When a Steering Control Module (SCM) is present, Assisted/Auto
Steering options will be available. For detailed setup instructions,
refer to your specific assisted/auto steering installation manual.
NOTE: An update of your SCM software will also be required when
updating an existing Matrix console to Matrix Pro.
1. Press CONFIGURATION side tab .
2. Press
AutoSteer
.
3. Select:
►On – enabled
►Off – disabled
4. Select from:
►Valve Setup – used to configure Valve Type, Valve Frequency,
Minimum Duty Cycle Left, Minimum Duty Cycle Right and
Maximum Duty Cycle
►Steering Settings – used to establish Coarse Adjustment, Fine
Adjustment, Deadband and Lookahead
►Valve Test – used to verify if steering is directed correctly
►Valve Diagnostics – used to test the valves to see if they are
connected properly
►Options: Steering Wheel Sensor – used to select whether the
steering disengage sensor is magnetic or pressure based
►Angle Sensor – used to establish the Steering Angle Sensor
(SAS) as the primary feedback sensor for auto steering,
calibrate the SAS and set an offset adjustment.
5. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.
Figure 3-17: AutoSteer
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config-> AutoSteer
Enabled
Valve Setup Steering Settings
Valve Test Valve diagnostics
Angle Sensor Options
On