TeeJet Matrix Pro 840G User Manual - Manual (Page 64)

57
98-05238 R1 EN-US
HOME
OVER
VIE
W
SE
TUP
POWER
APPENDIX
FULL SCREEN
INTR
ODUC
TION
GUID
ANCE
GpS
GPS is used to configure GPS Type and GPS Port.
NOTE: These settings are required for assisted/auto steering and tilt
sensor operation, as well as proper implement operation.
1. Press CONFIGURATION side tab .
2. Press
GPS
.
3. Select from:
►GPS Type – select GPS source transmissions
►GPS Port – sets (D)GPS COM port
►GPS Status – displays information for TeeJet Customer
Service use on GGA/VTG (Data Rates), Number of Satellites,
HDOP, PRN, GGA Quality, GPS Receiver and Receiver
Version
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Configuration screen.
Figure 6-53: GPS
Configuration
Vehicle implement
AutoSteer Tilt
lightbar GPS
Video
Config->GPS
GPS Status
GPS Port
GPS Type
information
internal
GPS/dGPS
GPS Type
GPS Type customizes the system to accept GPS source or DGPS
source transmissions. GLONASS is only available with a compatible
receiver.
1. Press DOWN arrow to access the list of options.
2. Select:
►GPS Only – uncorrected signals
►DGPS Only – differentially corrected signals
►GPS/DGPS – either type of signal
►GPS+GLONASS – uncorrected signals from both the GPS
and GLONASS systems
Figure 6-54: GPS Type
Config->GPS
GPS Status
GPS Port
GPS Type
information
internal
GPS/dGPS
GPS Only
dGPS Only
GPS/dGPS
GPS+GlONASS
GPS Port
GPS Port sets port transmission to Internal or External.
1. Press DOWN arrow to access the list of options.
2. Select:
►Internal – use the internal (D)GPS (if equipped) and transmit
out
►External – receive external (D)GPS data
NOTE: Working with GPS signals such as OmniStar HP/XP or RTK
will require GPS port to be set to External.
Figure 6-55: GPS Port
Config->GPS
GPS Status
GPS Port
GPS Type
information
GPS/dGPS
internal
internal
External