Configuration, Vehicle setup – TeeJet Matrix Pro 840G User Manual User Manual

Page 42

Advertising
background image

35

98-05238 R1 EN-US

HOME

OVER

VIE

W

SE

TUP

POWER

APPENDIX

FULL SCREEN

INTR

ODUC

TION

GUID

ANCE

Configuration is used to configure the Vehicle, Implement, AutoSteer,

Tilt, Lightbar, GPS and Video.
1. Press UNIT SETUP bottom tab .
2. Press CONFIGURATION side tab .
3. Select from:

►Vehicle – used to establish vehicle type, antenna height,

direction to boom and distance to boom

►Implement – used to establish number of boom sections,

guidance width, spray width, overlap percentage, implement

delay on time and implement delay off time

►AutoSteer – used to enable/disable assisted/auto steering as

well as establish valve setup settings, steering settings and

steering angle sensor settings; and preform valve tests and

valve diagnostics

►Tilt – used to enable/disable and calibrate the tilt function,

allowing for tilt correction for application on hilly or sloped

terrain

►Lightbar – used to establish LED brightness, LED mode and

LED spacing

►GPS – used to establish the GPS type and port as well as to

view GPS status information

►Video – used to set up individual cameras

Figure 6-6: Configuration Options

Configuration

Vehicle

implement

AutoSteer

Tilt

lightbar

GPS

Video

vehicle Setup

Vehicle Setup is used to configure Vehicle Type, Antenna Height, Direction to Boom and Distance to Boom.
1. Press CONFIGURATION side tab .
2. Press

Vehicle

.

3. Select from:

►Vehicle Type – used to select the type of vehicle steering that most closely represents your vehicle
►Antenna Height

– used to enter the height of the antenna from the ground

►Direction to Boom

– used to select whether the boom is located behind or in front of the GPS antenna

►Distance to Boom

– used to enter the distance from the GPS antenna to the boom

4. Press RETURN arrow

or CONFIGURATION side tab to return to the main Configuration screen

NOTE: All settings under Vehicle Setup are required for autosteer and tilt sensor operation, as well as proper implement operation.
Figure 6-7: Vehicle Setup Options

Configuration

Vehicle

implement

AutoSteer

Tilt

lightbar

GPS

Video

Config-> Vehicle

12.50 ft

0.00 ft

Front wheel

backward

Vehicle Type

Ant Height

dir to boom

dist to boom

CONFiGURATiON

Advertising
This manual is related to the following products: