Threading the machine – SINGER 3103 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Threading the Machine

» Place spool of thread on spool pin. if spool

being used has a thread retaining slit A, it

should be placed to the right, as illustrated.

• Raise the presser foot, to release thread

tension.

Raise the take-up lever to highest position

by turning hand wheel toward yotr.

# Holding thread ends in each hand, sr^p

thread into upper thread guidel.

O With right hand on thread spool, thread the

needle thread tension2. Slide thread over

metal plate between tension discs with left

hand.

Lead

thread

under

tension

and

tension wire. Thread tension wire by firmly

pulling thread up and over to the right.

o Thr^d take-up leverS, as illustrated.

O Draw thread through points4 and 5, guiding

thread from rear of each guide to the right.

Pass thread through guide 6. Thread the

needle 7 from front to back, drawing 10 cm

{4 inches) of thread through the needle eye.

23

Advertising
This manual is related to the following products:

968, 878, 563, 263