2 network connection, User manual, 1 setting the network camera over the lan – 3xLOGIC VISIX Camera User Manual

Page 11

Advertising
background image

User  Manual  

|  VISIX  PTZ  Network  Camera  

 

 

10225  Westmoor  Drive,  Suite  300,  Westminster,  CO  80021  |  www.3xlogic.com  |  (877)  3XLOGIC

 

 

3  

2 Network  Connection  

 
Before  you  start:  

!

If  you  want  to  set  the  network  camera  via  a  LAN  (Local  Area  Network),  please  refer  to  Section  2.1  Setting  the  
Network  Camera  over  the  LAN
.
 

!

If  you  want  to  set  the  network  camera  via  a  WAN  (Wide  Area  Network),  please  refer  to  Section  2.2  Setting  the  
Network  Camera  over  the  WAN
.
 

!

 

2.1 Setting  the  Network  Camera  over  the  LAN  

Purpose:  
To  view  and  configure  the  camera  via  a  LAN,  you  need  to  connect  the  network  camera  in  the  same  subnet  with  
your  computer,  and  install  the  3xLOGIC  VISIX  detection  software.  This  will  allow  you  to  search  and  change  the  IP  
address     of  the  detected  network  cameras.  

NOTE:

 

For  the  detailed  introduction  of  the  3xLOGIC  VISIX  camera  detection  software,  please  refer  to  this  

link:  

http://www.3xlogic.com/3xdocuments/kb-­‐article/130005-­‐1-­‐guide-­‐visix-­‐setup-­‐utility-­‐guide

 

WIRING  OVER  THE  LAN  

The  following  figures  show  the  two  methods  of  cable  connection  between  a  network  camera  and  a  computer:  
Purpose:  

!

To  test  the  network  camera,  you  can  directly  connect  the  network  camera  to  the  computer  with  a  network  
cable  as  shown  in  Figure  2-­‐1.  

!

Refer  to  the  Figure  2-­‐2  to  set  network  camera  over  the  LAN  via  a  switch  or  a  router.  

 

Figure  2-­‐1

Connecting  Directly  

 

Figure  2-­‐2

Connecting  via  a  Switch  or  a  Router  

 

 

Advertising