User manual, 8 configuring ptz control priority, 9 clearing ptz configurations – 3xLOGIC VISIX Camera User Manual

Page 34

Advertising
background image

User  Manual  

|  VISIX  PTZ  Network  Camera  

 

 

10225  Westmoor  Drive,  Suite  300,  Westminster,  CO  80021  |  www.3xlogic.com  |  (877)  3XLOGIC

 

 

26  

5) Set  the  tracking  duration.  The  speed  dome  stops  tracking  when  the  duration  time  is  up.  The  

duration  ranges  from  0  to  300  seconds.  

 

NOTE:  

!

Setting  the  duration  to  0  means  that  there’s  no  duration  when  speed  dome  tracks.  

!

Not  all  the  speed  dome  models  support  this  function.  Please  take  the  browser  interface  of  
the  actual  product  as  standard.  

5.8 Configuring  PTZ  Control  Priority  

!

The  speed  dome  can  be  controlled  by  network  and  RS-­‐485  signals.  You  can  set  the  control  
priority  of  these  two  signals.  

!

The  operation  of  Operator  is  prior  to  that  of  User.  When  the  Operator  is  controlling  the  
speed  dome,  the  User  cannot  control  it.  When  the  Operator  finishes,  the  User  can  control  
the  speed  dome  after  the  Delay  time.  The  Delay  time  can  be  set  in  Priority  PTZ  interface  as  
shown  follows.  

 

Figure  5-­‐13

PTZ  Priority  

 

5.9 Clearing  PTZ  Configurations  

Purpose:  
You  can  clear  PTZ  configurations  in  this  interface,  including  all  presets,  patrols,  patterns,  privacy  
masks,  PTZ  limits  and  scheduled  tasks.  
Steps:  

1) Enter  the  Clearing  Configuration  interface:  

Configuration  >  Advanced  Configuration>  PTZ  >  Clear  Config  

2) Check  the  checkbox  of  the  items  you  want  to  clear.  

3) Click  

  to  clear  the  settings.  

 

Advertising