User manual – 3xLOGIC VISIX Camera User Manual

Page 73

Advertising
background image

User  Manual  

|  VISIX  PTZ  Network  Camera  

 

 

10225  Westmoor  Drive,  Suite  300,  Westminster,  CO  80021  |  www.3xlogic.com  |  (877)  3XLOGIC

 

 

65  

 

Figure  7-­‐4

Recording  Schedule  Interface  

 
2) Check  the  checkbox  of  Enable  Record  Schedule  to  enable  scheduled  recording.  
3) Set  the  record  parameters  of  the  speed  dome.  

 

Record  Parameters  
 

!

Pre-­‐record:  The  time  you  set  to  start  recording  before  the  scheduled  time  or  the  event.  For  
example,  if  an  alarm  triggers  recording  at  10:00,  and  the  pre-­‐record  time  is  set  as  5  seconds,  
the  speed  dome  starts  to  record  at  9:59:55.  

!

The  Pre-­‐record  time  can  be  configured  as  No  Pre-­‐record,  5  s,  10  s,  15  s,  20  s,  25  s,  30  s  or  not  
limited.  

NOTE:

 The  pre-­‐record  time  changes  according  to  the  video  bitrate.  

!

Post-­‐record:  The  time  you  set  to  stop  recording  after  the  scheduled  time  or  the  event.  For  
example,  if  an  alarm  triggered  recording  ends  at  11:00,  and  the  post-­‐record  time  is  set  as  5  
seconds,  the  speed  dome  records  until  11:00:05.  

!

The  Post-­‐record  time  can  be  configured  as  5  s,  10  s,  30  s,  1  min,  2  min,  5  min  or  10  min.  

!

Overwrite:  If  you  enable  his  function  and  the  HDD  is  full,  the  new  record  files  overwrite  the  
oldest  record  files  automatically.  

NOTE:

 The  Pre-­‐record  and  Post-­‐record  parameters  vary  depending  on  the  speed  dome  

model.  

4) Click  

  to  edit  the  record  schedule.  

Advertising