User manual – 3xLOGIC VISIX Camera User Manual

Page 5

Advertising
background image

User  Manual  

|  VISIX  PTZ  Network  Camera  

 

 

10225  Westmoor  Drive,  Suite  300,  Westminster,  CO  80021  |  www.3xlogic.com  |  (877)  3XLOGIC

 

 

5  

!

Cautions:    

!

Make  sure  the  power  supply  voltage  is  correct  before  using  the  camera.  

!

Do  not  drop  the  camera  or  subject  it  to  physical  shock.  

!

Do  not  touch  sensor  modules  with  fingers.  If  cleaning  is  necessary,  use  a  clean  cloth  with  a  bit  of  
ethanol  and  wipe  it  gently.  If  the  camera  will  not  be  used  for  an  extended  period  of  time,  put  on  
the  lens  cap  to  protect  the  sensor  from  dirt.    

!

Do  not  aim  the  camera  lens  at  the  strong  light  such  as  sun  or  incandescent  lamp.  The  strong  light  
can  cause  fatal  damage  to  the  camera.  

!

The  sensor  may  be  burned  out  by  a  laser  beam,  so  when  any  laser  equipment  is  being  used,  make  
sure  that  the  surface  of  the  sensor  not  be  exposed  to  the  laser  beam.  

!

Do  not  place  the  camera  in  extremely  hot,  cold  temperatures  (the  operating  temperature  should  
be  between  -­‐30°C  ~  60°C,  or  -­‐40°C  ~  60°C  if  the  camera  model  has  an  “H”  in  its  suffix),  dusty  or  
damp  environment,  and  do  not  expose  it  to  high  electromagnetic  radiation.    

!

To  avoid  heat  accumulation,  good  ventilation  is  required  for  a  proper  operating  environment.    

!

Keep  the  camera  away  from  water  and  any  liquid.  

!

While  shipping,  the  camera  should  be  packed  in  its  original  packing.  

!

Improper  use  or  replacement  of  the  battery  may  result  in  hazard  of  explosion.  Please  use  the  
manufacturer  recommended  battery  type.  

 

Notes:  

For  cameras  that  support  IR,  you  are  required  to  pay  attention  to  the  following  precautions  to  prevent  
IR  reflection:    

!

Dust  or  grease  on  the  dome  cover  will  cause  IR  reflection.  Please  do  not  remove  the  dome  cover  
film  until  the  installation  is  finished.  If  there  is  dust  or  grease  on  the  dome  cover,  clean  the  dome  
cover  with  clean  soft  cloth  and  isopropyl  alcohol.  

!

Make  certain  the  installation  location  does  not  have  reflective  surfaces  of  objects  too  close  to  the  
camera.  The  IR  light  from  the  camera  may  reflect  back  into  the  lens  causing  reflection.    

!

The  foam  ring  around  the  lens  must  be  seated  flush  against  the  inner  surface  of  the  bubble  to  
isolate  the  lens  from  the  IR  LEDS.  Fasten  the  dome  cover  to  camera  body  so  that  the  foam  ring  
and  the  dome  cover  are  attached  seamlessly.    

Advertising