3xLOGIC VISIX Camera User Manual

Page 29

Advertising
background image

User  Manual  

|  VISIX  PTZ  Network  Camera  

 

 

10225  Westmoor  Drive,  Suite  300,  Westminster,  CO  80021  |  www.3xlogic.com  |  (877)  3XLOGIC

 

 

21  

5.3 Configuring  PTZ  Limit  Stops  

Purpose:  
The  dome  can  be  programmed  to  move  within  the  configurable  limit  stops  (left/right,  up/down).  
Steps:  

1)

Enter  the  Limit  Configuration  interface:  
Configuration  >  Advanced  Configuration  >  PTZ  >  Limit  

 

Figure  5-­‐3

Configure  the  PTZ  Limit  

2)

Click  the  checkbox  of  Enable  Limit  and  choose  the  limit  type  as  manual  stops  or  scan  stops.  

!

Manual  Stops:  

When  manual  limit  stops  are  set,  you  can  operate  the  PTZ  control  panel  manually  only  in  the  
limited  surveillance  area.  

!

Scan  Stops:  

When  scan  limit  stops  are  set,  the  random  scan,  frame  scan,  auto  scan,  tilt  scan,  panorama  
scan  is  performed  only  in  the  limited  surveillance  area.  

NOTE:

 Manual  Stops  of  Limit  Type  is  prior  to  Scan  Stops.  When  you  set  these  two  limit  types  

at  the  same  time,  Manual  Stops  is  valid  and  Scan  Stops  is  invalid.  

3)

Click  the  PTZ  control  buttons  to  find  the  left/right/up/down  limit  stops;  you  can  also  call  the  
defined  presets  and  set  them  as  the  limits  of  the  dome.  

4)

Click  Set  to  save  the  limits  or  click  Clear  to  clear  the  limits.  

 

5.4 Configuring  Scheduled  Tasks  

Purpose:  
You  can  configure  the  network  dome  to  perform  a  certain  action  automatically  in  a  user-­‐defined  time  
period.  
Steps:  

1) Enter  the  Scheduled  Task  Settings  interface:  

Configuration>  Advanced  Configuration>  PTZ  >  Scheduled  Tasks  

Advertising