ADLINK PCI-8102 - Manual (Page 136)

Function Library 125
PCI-8102
1: on board DIP switch (SW1).
card_id: Specify the PCI-8102 card index. The card_id could be
decided by DIP switch (SW1) or depend on slot sequence.Please
refer to _8102_initial().
firmware_ver: The current firmware version.
driver_ver: The current device driver version.
dll_ver: The current DLL library version.
Length: Array size. Length = 1~12
*sec_code: A numerical array, the array size would be set
between 1 and 12.
6.4 Pulse Input/Output Configuration
@ Name
_8102_set_pls_iptmode – Set the configuration for
feedback pulse input.
_8102_set_pls_outmode – Set the configuration for
pulse command output.
_8102_set_feedback_src – Enable/Disable the
external feedback pulse input
@ Description
_8102_set_pls_iptmode:
Configure the input modes of external feedback pulses. There are
four types for feedback pulse input. Note that this function makes
sense only when the Src parameter in _8102_set_feedback_src()
function is enabled.
_8102_set_pls_outmode:
Configure the output modes of command pulses. There are 6
modes for command pulse output.
_8102_set_feedback_src:
If external encoder feedback is available in the system, set the Src
parameter in this function to an Enabled state. Then, the internal
28-bit up/down counter will count according to the configuration of