7 k1/k2 pin assignments: simultaneous start/ stop, 8 jumper settings for pulse output, K1/k2 pin assignments: simultaneous start/stop – ADLINK PCI-8102 User Manual

Page 28: Jumper settings for pulse output

Advertising
background image

Installation

17

PCI-8102

2.7

K1/K2 Pin Assignments: Simultaneous Start/

Stop

CN4 is for simultaneous start/stop signals for multiple axes or mul-
tiple cards.

Note: +5V and GND pins are provided by the PCI Bus power.

2.8

Jumper Settings for Pulse Output

J8-J11 are used to set the type of pulse output signals (DIR and
OUT). The output signal type can either be differential line driver
or open collector output. Refer to section 3.1 for detail jumper set-
tings. The default setting is differential line driver mode. The
default setting is differential line driver mode. J8 & J9 are for axis
0; J10 & J11 are for axis 1.

No.

Name

Function (Axis)

1

+5V

PCI Bus power Output (VCC)

2

STA

Simultaneous start signal input/output

3

STP

Simultaneous stop signal input/output

4

GND

PCI Bus power ground

Advertising