Configuring the service rule – Cisco ASA 5505 User Manual

Page 1157

Advertising
background image

54-13

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 54 Configuring QoS

Configuring QoS

Restrictions

For hierarchical priority queuing, for encrypted VPN traffic, you can only match traffic based on the
DSCP or precedence setting; you cannot match a tunnel group.

For hierarchical priority queuing, IPsec-over-TCP traffic is not supported.

Detailed Steps

Configuring the Service Rule

To configure traffic shaping and optional hiearchical priority queuing, perform the following steps.

Restrictions

Traffic shaping is not supported on the multi-processor models.

For traffic shaping, you can only use the class-default class map, which is automatically created by
the ASA, and which matches all traffic.

You cannot configure traffic shaping and standard priority queuing for the same interface; only
hierarchical priority queuing is allowed. See the

“How QoS Features Interact” section on page 54-4

for information about valid QoS configurations.

You cannot configure traffic shaping in the global policy.

Command

Purpose

Step 1

class-map

priority_map_name

Example:

hostname(config)# class-map

priority_traffic

For hierarchical priority queuing, creates a class map to identify
the traffic for which you want to perform priority queuing.

Step 2

match

parameter

Example:

hostname(config-cmap)# match access-list

priority

Specifies the traffic in the class map. See the

“Identifying Traffic

(Layer 3/4 Class Maps)” section on page 32-12

for more

information. For encrypted VPN traffic, you can only match
traffic based on the DSCP or precedence setting; you cannot
match a tunnel group.

Step 3

policy-map

priority_map_name

Example:

hostname(config)# policy-map

priority-sub-policy

Creates a policy map.

Step 4

class

priority_map_name

Example:

hostname(config-pmap)# class

priority-sub-map

Specifies the class map you created in

Step 1

.

Step 5

priority

Example:

hostname(config-pmap-c)# priority

Applies the priority queuing action to a class map.

Note

This policy has not yet been activated. You must activate
it as part of the shaping policy. See the

“Configuring the

Service Rule” section on page 54-13

.

Advertising