Cisco ASA 5505 User Manual

Page 327

Advertising
background image

9-17

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 9 Completing Interface Configuration (Transparent Mode)

Completing Interface Configuration in Transparent Mode

Configuring a Global IPv6 Address and Other Options

To configure a global IPv6 address and other options for a bridge group or management interface,
perform the following steps.

Note

Configuring the global address automatically configures the link-local address, so you do not need to
configure it separately.

Restrictions

The ASA does not support IPv6 anycast addresses.

Prerequisites

Set up your interfaces depending on your model:

ASA 5510 and higher—

Chapter 6, “Starting Interface Configuration (ASA 5510 and Higher).”

ASA 5505—

Chapter 7, “Starting Interface Configuration (ASA 5505).”

In multiple context mode, you can only configure context interfaces that you already assigned to the
context in the system configuration according to the

“Configuring Multiple Contexts” section on

page 5-14

.

In multiple context mode, complete this procedure in the context execution space. To change from
the system to a context configuration, enter the changeto context name command.

Detailed Steps

Command

Purpose

Step 1

For the bridge group:

interface

bvi bridge_group_id

For the management interface:

interface

management_interface_id

Example:

hostname(config)# interface bvi 1

If you are not already in interface configuration mode, enters
interface configuration mode.

Step 2

ipv6 address

ipv6-address/prefix-length

[standby ipv6-address]

Example:

hostname(config-if)# ipv6 address

2001:0DB8::BA98:0:3210/48

Assigns a global address to the interface. When you assign a
global address, the link-local address is automatically created for
the interface (for a bridge group, for each member interface).

standby specifies the interface address used by the secondary unit
or failover group in a failover pair.

Note

The eui-64 keyword to use the Modified EUI-64 interface
ID for the interface ID is not supported in transparent
mode.

See the

“IPv6 Addresses” section on page B-5

for more

information about IPv6 addressing.

Advertising