Restarting the eigrp process, Monitoring eigrp – Cisco ASA 5505 User Manual

Page 525

Advertising
background image

27-17

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 27 Configuring EIGRP

Monitoring EIGRP

To disable EIGRP split horizon, perform the following steps:

Detailed Steps

Restarting the EIGRP Process

To restart an EIGRP process or clear redistribution or counters, enter the following command:

Monitoring EIGRP

You can use the following commands to monitor the EIGRP routing process. For examples and
descriptions of the command output, see the command reference. Additionally, you can disable the
logging of neighbor change messages and neighbor warning messages.

To monitor or disable various EIGRP routing statistics, enter one of the following commands:

Command

Purpose

Step 1

interface

phy_if

Example:

hostname(config)# interface phy_if

Enters interface configuration mode for the interface on which
you are changing the delay value used by EIGRP.

Step 2

no split-horizon eigrp

as-number

Example:

hostname(config-if)# no split-horizon

eigrp 2

Disables the split horizon.

Command

Purpose

clear eigrp pid

{1-65535 | neighbors | topology |

events)

}

Example:

hostname(config)# clear eigrp pid 10 neighbors

Restarts an EIGRP process or clears redistribution or counters.

Command

Purpose

Monitoring EIGRP Routing

show eigrp

[as-number] events [{start end}

| type]

Displays the EIGRP event log.

show eigrp

[as-number] neighbors [detail |

static

] [if-name]

Displays the EIGRP neighbor table.

show eigrp

[as-number] interfaces [if-name]

[detail]

Displays the interfaces participating in EIGRP
routing.

show eigrp

[as-number] topology [ip-addr

[mask] | active | all-links | pending |

summary

| zero-successors]

Displays the EIGRP topology table.

Advertising