Cisco ASA 5505 - Manual (Page 1754)

77-12
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 77 Configuring Logging
Configuring Logging
Sending Syslog Messages to a Telnet or SSH Session
To send syslog messages to a Telnet or SSH session, perform the following steps:
Command Purpose
Step 1 logging monitor {severity_level | message_list}
Example:
hostname(config)# logging monitor 6
Specifies which syslog messages should be sent to a
Telnet or SSH session.
Step 2 terminal monitor
Example:
hostname(config)# terminal monitor
Enables logging to the current session only. If you log
out and then log in again, you need to reenter this
command. To disable logging to the current session,
enter the terminal no monitor command.