Understanding asa 5505 ports and interfaces, Maximum active vlan interfaces for your license – Cisco ASA 5505 User Manual
Page 280
7-2
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 7 Starting Interface Configuration (ASA 5505)
Information About ASA 5505 Interfaces
Understanding ASA 5505 Ports and Interfaces
The ASA 5505 supports a built-in switch. There are two kinds of ports and interfaces that you need to
configure:
•
Physical switch ports—The ASA has 8 Fast Ethernet switch ports that forward traffic at Layer 2,
using the switching function in hardware. Two of these ports are PoE ports. See the
for more information. You can connect these interfaces directly to
user equipment such as PCs, IP phones, or a DSL modem. Or you can connect to another switch.
•
Logical VLAN interfaces—In routed mode, these interfaces forward traffic between VLAN
networks at Layer 3, using the configured security policy to apply firewall and VPN services. In
transparent mode, these interfaces forward traffic between the VLANs on the same network at Layer
2, using the configured security policy to apply firewall services. See the
section for more information about the maximum VLAN interfaces.
VLAN interfaces let you divide your equipment into separate VLANs, for example, home, business,
and Internet VLANs.
To segregate the switch ports into separate VLANs, you assign each switch port to a VLAN interface.
Switch ports on the same VLAN can communicate with each other using hardware switching. But when
a switch port on VLAN 1 wants to communicate with a switch port on VLAN 2, then the ASA applies
the security policy to the traffic and routes or bridges between the two VLANs.
Maximum Active VLAN Interfaces for Your License
In routed mode, you can configure the following VLANs depending on your license:
•
Base license—3 active VLANs. The third VLAN can only be configured to initiate traffic to one
other VLAN. See
for more information.
•
Security Plus license—20 active VLANs.
In transparent firewall mode, you can configure the following VLANs depending on your license:
•
Base license—2 active VLANs in 1 bridge group.
•
Security Plus license—3 active VLANs: 2 active VLANs in 1 bridge group, and 1 active VLAN for
the failover link.
Note
An active VLAN is a VLAN with a nameif command configured.