Cisco ASA 5505 - Manual (Page 1875)

A-1
Cisco ASA 5500 Series Configuration Guide using the CLI
A P P E N D I X
A
Using the Command-Line Interface
This appendix describes how to use the CLI on the ASA and includes the following sections:
• Firewall Mode and Security Context Mode, page A-1
• Command Modes and Prompts, page A-2
• Syntax Formatting, page A-3
• Abbreviating Commands, page A-3
• Command-Line Editing, page A-3
• Command Completion, page A-4
• Command Help, page A-4
• Filtering show Command Output, page A-4
• Command Output Paging, page A-5
• Adding Comments, page A-5
• Text Configuration Files, page A-5
• Supported Character Sets, page A-8
Note The CLI uses similar syntax and other conventions to the Cisco IOS CLI, but the ASA operating system
is not a version of Cisco IOS software. Do not assume that a Cisco IOS CLI command works with or has
the same function on the ASA.
Firewall Mode and Security Context Mode
The ASA runs in a combination of the following modes:
• Transparent firewall or routed firewall mode
The firewall mode determines if the ASA runs as a Layer 2 or Layer 3 firewall.
• Multiple context or single context mode
The security context mode determines if the ASA runs as a single device or as multiple security
contexts, which act like virtual devices.
Some commands are only available in certain modes.