Cisco ASA 5505 - Manual (Page 1263)

59-17
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 59 Configuring the ASA CX Module
Troubleshooting the ASA CX Module
TCP outside 208.80.152.2:80 inside 192.168.1.20:59928, idle 0:00:10, bytes 79174, flags
XUIO
Capturing Module Traffic
To configure and view packet captures for the ASA CX module, enter one of the following commands:
Note Captured packets contain an additional AFBP header that your PCAP viewer might not understand; be
sure to use the appropriate plugin to view these packets.
Troubleshooting the ASA CX Module
• General Recovery Procedures, page 59-17
• Debugging the Module, page 59-19
• Problems with the Authentication Proxy, page 59-20
General Recovery Procedures
This section includes procedures that help you recover or troubleshoot the module and includes the
following topics:
• Resetting the Password, page 59-17
• Reloading or Resetting the Module, page 59-18
• Shutting Down the Module, page 59-19
Note You can install or upgrade your image from within the ASA CX module. See the ASA CX module
documentaiton for more information.
Resetting the Password
You can reset the module password to the default. For the user admin, the default password is
Admin123. After resetting the password, you should change it to a unique value using the module
application.
Resetting the module password causes the module to reboot. Services are not available while the module
is rebooting.
Command Purpose
capture name interface asa_dataplane Captures packets between ASA CX module and the ASA on the
backplane.
copy capture Copies the capture file to a server.
show capture Shows the capture at the ASA console.