Configuration examples for snmp, Configuration example for snmp versions 1 and 2c, Configuration example for snmp version 3 – Cisco ASA 5505 User Manual

Page 1808

Advertising
background image

79-28

Cisco ASA 5500 Series Configuration Guide using the CLI

Chapter 79 Configuring SNMP

Configuration Examples for SNMP

0 Get-bulk PDUs

0 Set-request PDUs (Not supported)

0 SNMP packets output

0 Too big errors (Maximum packet size 512)

0 No such name errors

0 Bad values errors

0 General errors

0 Response PDUs

0 Trap PDUs

The following example shows how to display the SNMP server running configuration:

hostname(config)# show running-config snmp-server

no snmp-server location

no snmp-server contact

snmp-server enable traps snmp authentication linkup linkdown coldstart

Configuration Examples for SNMP

This section includes the following topics:

Configuration Example for SNMP Versions 1 and 2c, page 79-28

Configuration Example for SNMP Version 3, page 79-28

Configuration Example for SNMP Versions 1 and 2c

The following example shows how the ASA can receive SNMP requests from host 192.0.2.5 on the
inside interface but does not send any SNMP syslog requests to any host:

hostname(config)# snmp-server host 192.0.2.5

hostname(config)# snmp-server location building 42

hostname(config)# snmp-server contact EmployeeA

hostname(config)# snmp-server community ohwhatakeyisthee

Configuration Example for SNMP Version 3

The following example shows how the ASA can receive SNMP requests using the SNMP Version 3
security model, which requires that the configuration follow this specific order: group, followed by user,
followed by host:

hostname(config)# snmp-server group v3 vpn-group priv

hostname(config)# snmp-server user admin vpn group v3 auth sha letmein priv 3des cisco123

hostname(config)# snmp-server host mgmt 10.0.0.1 version 3 priv admin

Advertising