Cisco ASA 5505 - Manual (Page 448)

22-2
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 22 Configuring Static and Default Routes
Licensing Requirements for Static and Default Routes
syslog server, Websense or N2H2 server, or AAA server. If you have servers that cannot all be reached
through a single default route, then you must configure static routes. Additionally, the ASA supports up
to three equal cost routes on the same interface for load balancing.
Licensing Requirements for Static and Default Routes
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
IPv6 Guidelines
Supports IPv6.
Failover Guidelines
Supports stateful failover of dynamic routing protocols.
Additional Guidelines
IPv6 static routes are not supported in transparent mode in ASDM.
Configuring Static and Default Routes
This section explains how to configure a static route and a static default route, and includes the following
topics:
• Configuring a Static Route, page 22-3
• Configuring a Default Static Route, page 22-4
• Configuring IPv6 Default and Static Routes, page 22-5
Model License Requirement
All models Base License.