Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 133)

Ethernet Interface
ATCA-9305 User’s Manual (10009109-07) 133
6.2.3 VLAN Setup
The default VLAN configuration is defined in Table 6-2 . See vlan on page 258 for the monitor
vlan command.
6.3 MPC8548 Management Processor Ethernet
Address
The Ethernet address for your board is a unique identifier on a network. The address consists of
48 bits (MAC [47:0]) divided into two equal parts. The upper 24 bits define a unique identifier
that has been assigned to Artesyn Embedded Technologies - Embedded Computing by IEEE.
The lower 24 bits are defined by Artesyn for identification of each of our products.
The Ethernet address for the ATCA-9305 is a binary number referenced as 12 hexadecimal
digits separated into pairs, with each pair representing eight bits. The address assigned to the
ATCA-9305 has the following form:
15 XAUI 10 GB BCM56802 to J31 to optional RTM
16
17
18
Table 6-1 Ethernet Switch Ports (continued)
Port Interface Connection
Table 6-2 VLAN Configuration
VLAN Ports
1 1, 3, 4
2 6, 7
3 8, 13
4 5, 11
5 12, 14