Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 231)

Management Processor Monitor
ATCA-9305 User’s Manual (10009109-07) 231
bootv <primary|secondary> write <source> <dest> <size>
Update NVRAM based on image already in flash.
bootv <primary|secondary> update <source> <size>
Check validity of images in flash.
bootv <primary|secondary> check
9.6.6 bootvx
The bootvx command boots VxWorks
®
from an ELF image, where address is the load address
of the VxWorks ELF image. To use this command, the environment variables listed in Table 9-4
must be configured.
Definition
bootvx [ address ]
9.6.7 dhcp
The dhcp command invokes a Dynamic Host Configuration Protocol (DHCP) client to obtain IP
and boot parameters by sending out a DHCP request and waiting for a response from a server.
Definition
dhcp [loadaddress] [bootfilename]
To use the dhcp command, your DHCP server must be configured with the variables designated
in
Table 9-5 .
Table 9-5 DHCP Ethernet Configuration
Environment Variable Description Value 1
ipaddr
Local IP address for the board, configured by
DHCP e.g., 192.168.1.1
serverip
TFTP/NFS server address value must be
configured after the DHCP IP address is
acquired
2
e.g., 192.168.1.2