Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 174)

System Management
ATCA-9305 User’s Manual (10009109-07) 174
7.11.4 Get Debug Level
The Get Debug Level command gets the current debug level of the IPMC firmware.
Table 7-20 Get Debug Level Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5 Bits [7:5] reserved
Bit [4] IPMB Dump Enable
If set to 1, the IPMC provides a trace of IPMB messages that are arriving
to/going from the IPMC via IPMB-0 or IPMB -L
Bit [3] Payload Logging Enable
If set to 1, the IPMC provides a trace of SIPL activity on the Payload
interface onto the Serial Debug interface
Bit [2] Alert Logging Enable
If set to 1, the IPMC outputs important alert messages onto the Serial
Debug interface
Bit [1] Low-level Error Logging Enable
If set to 1, the IPMC outputs low-level error/diagnostic messages onto
the Serial Debug interface
Bit [0] Error Logging Enable
If set to 1, the IPMC outputs error/diagnostic messages onto the Serial
Debug interface