Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 247)

Management Processor Monitor
ATCA-9305 User’s Manual (10009109-07) 247
9.11.7 ipmchpmfw
The ipmchpmfw command restores the previous IPMC firmware from the backup IPMC
firmware stored in the controller. The upgrade argument upgrades the IPMC firmware with the
upgrade image held in memory.
Definition
ipmchpmfw [restore] [upgrade <source address>]
9.11.8 sensor
The sensor command probes, reads, and prints the sensor information from the IPMI.
Definition
sensor [probe|read|dump]
Sensor probe prints out each sensor number and name.
sensor probe <sensor number>
Sensor read prints out the sensor reading for sensor.
sensor read <sensor number>
Sensor dump prints out the raw Sensor Data Record (SDR) information for sensor.
sensor dump <sensor number>
9.12 Environment Parameter Commands
The monitor uses on-board, non-volatile memory for the storage of environment parameters.
Environment parameters are stored as ASCII strings with the following format.
<Parameter Name>=<Parameter Value>
Some environment variables are used for board configuration and identification by the
monitor. The environment parameter commands deal with the reading and writing of these
parameters. Refer to
MPC8548 Environment Variables on page 260 for a list of monitor
environment variables.