2 get led color capabilities command, Table 7-13, Get led color capabilities command – Artesyn ATCA-9305 User's Manual (May 2014) User Manual
Page 161: System management
System Management
ATCA-9305 User’s Manual (10009109-07)
161
7.10.2 Get LED Color Capabilities Command
LED 1 can be either red or amber, this command is used to determine the valid color prior to
issuing a Set FRU LED State command.
Table 7-13 Get LED Color Capabilities Command
Type
Byte
Data Field
Request Data
1
PICMG Identifier—indicates that this is a PICMG defined group extension
command. Use value 00h.
2
FRU Device ID
3
LED ID
FFh reserved
Response Data 1
Completion Code
CCh If the LED ID contained in the Request data is not present on the FRU
2
PICMG Identifier—indicates that this is a PICMG defined group extension
command. Use value 00h.
3
LED Color Capabilities—when a bit is set, the LED supports the color.
Bit [7] reserved, set to 0
Bit [6] LED supports white
Bit [5] LED supports orange
Bit [4] LED supports amber
Bit [3] LED supports green
Bit [2] LED supports red
Bit [1] LED supports blue
Bit [0] reserved, set to 0