Artesyn ATCA-9305 User's Manual (May 2014) - Manual (Page 232)

Management Processor Monitor
ATCA-9305 User’s Manual (10009109-07) 232
9.6.8 rarpboot
The rarpboot command boots an image via a network connection using the RARP/TFTP
protocol. If loadaddress or bootfilename is not specified, the environment variables loadaddr
and bootfile are used as the default. To use this command, the environment variables listed in
Table 9-4 must be configured.
Definition
rarpboot [loadaddress] [bootfilename]
netmask
Net mask, obtained by DHCP -
gatewayip
Gateway IP address, obtained by DHCP -
ethport
eTSEC1 default -
ethaddr
3 MAC address 00:80:F9:xx:xx:xx
autoload
4 Boot image from TFTP server after DHCP
acquisition no
Table 9-5 DHCP Ethernet Configuration (continued)
Environment Variable Description Value 1
 Values for ethaddr, netdev and autoload are set by the user.
 The value obtained by the DHCP server may not be applicable to your development
application.
 Ensure that each MAC address on the network is unique.
 If autoload is not set or configured to “yes,” ensure that the DHCP provides proper
information for autoboot. If proper autoboot information is not provided, an error may
occur.