2 power-up/reset sequence, Figure 3-3, Example cavium cn5860 monitor start-up display – Artesyn ATCA-9305 User's Manual (May 2014) User Manual
Page 77
Cavium Processor Complex
ATCA-9305 User’s Manual (10009109-07)
77
attempts to load the application from the specified device. If the monitor is not configured for
autoboot or a failure occurs during power-up, the monitor enters normal command-line mode.
The monitor command prompt in
is the result of a successful hardware boot of the
ATCA-9305.
3.4.2
Power-up/Reset Sequence
The Cavium CN5860 processor follows the boot sequence in
before auto-booting
the operating system or application software. At power-up or board reset, the monitor
performs hardware initialization, diagnostic routines, autoboot procedures, and if necessary,
invokes the command line. See
for default Cavium environment variables settings.
Figure 3-3
Example Cavium CN5860 Monitor Start-up Display
There will be either a 1 or 2 in front of the monitor prompt indicating which Cavium processor
is prompting.