Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 127)

4-86 Programmer’s Manual
Example
#include <stdio.h>
#include "scan1223.h"
#include "mmsultra.h"
void main(void)
{
short sStatus = 0; // Command calls status
LPGENERALINFO GENconfig; // General data structure
sStatus = scnOpenScanner(); // Enable scanner
if (sStatus == -2)
printf("Scanner error-- %d", sStatus);
else
{ // Get config.
sStatus = scnGetGeneralInfo(GENconfig);
if (sStatus != 0)
printf("Scanner is disabled.");
else
{ // Set values
GENconfig->uchLaserOnTime = 40;
GENconfig->uchPowerMode = 1;
GENconfig->uchTriggerMode = 1;
GENconfig->uchSameSymbolTMO = 10;
GENconfig->uchLinearCodeSecur = 1;
GENconfig->uchBiDirRedun = SCN_DISABLE;
// Save values
sStatus = scnSetGeneralInfo(GENconfig);
if (sStatus != 0)
printf("Error setting values-- ", sStatus);
else
; /* Scan Bar Codes */
}
}
sStatus = scnCloseScanner(); // Disable scanner
}