Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 35)

3-8 Programmer’s Manual
You can also link to any standard C/C++
libraries.
U s i n g R E M S E R V a n d R E M D I S K
To enable the printer to access a disk drive on the PC:
1. Connect the printer and the PC with a PC cable (see
“Hardware Requirements” in Chapter 1). Attach one end of
the cable to the serial port on the printer and the other end
to the serial port on the PC.
2. Run the REMSERV Utility on the PC and the REMDISK
Utility on the printer. You can start either utility first. Both
utilities must use the same baud rate and transmission
style (packet/non-packet).
See “REMSERV” and “REMDISK” in Chapter 7 for more
information.
3. When you run REMDISK, it specifies the printer drive letter
corresponding to the shared PC drive. On the printer, use
this letter and any DOS command to access the PC’s disk
drive.