Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 36)

Developing Applications 3-9
T e s t i n g t h e A p p l i c a t i o n
Although you can do some limited testing on the PC, you test
mostly on the printer. You can
♦
load and run the application on the printer. If you choose
this option, continue with “Creating Disk Images.”
♦
run the application on the printer even though the executable
file resides on the PC. If you are going make many changes
to the application, this option is quicker and easier. To do
so:
1. Connect one end of a cable (see “Hardware
Requirements” in Chapter 1) to the printer and the other
end to the PC.
2. Run the REMSERV on the PC.
3. Run the REMDISK on the printer.
4. On the printer, change to the shared PC drive. Then,
maneuver to the directory containing the executable file.
5. At the printer’s DOS prompt, start the application.
Running the application on the printer when
the executable file resides on the PC may
result in several extra seconds to start the
application.