Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 207)

7-16 Programmer’s Manual
Parameters
drive The letter of the drive to make available.
options… Any of the following options. In most environments,
you can use the defaults for each option.
/Bnnnn Specifies to use baud rate nnnn.
Values for nnnn are: 300, 1200, 2300,
4800, 9600, 19200, 38400, 57600, and
115k . The default is 115k.
+ Specifies to use packet transmissions.
If you do not specify this option, the
default depends on the baud rate. For
baud rates over 19200, REMDISK uses
packet transmissions. For baud rates
at or below 19200, REMDISK uses
non-packet transmissions.
/COM1 Specifies to use the COM1 serial
communications port.
/S Specifies to run REMSERV silently
without any screen output.
/Tnnnn Specifies nnnn as the time-out in
seconds. Values are 3-3640.
/? Displays a short help screen
Help Screen Notes
Note the following help screen discrepancies that appear if you
use the /? option:
♦
The /n before the example should not appear.
♦
The /H option appears on the screen, but is non-functional.
Do not use it.
♦
You can press any key to exit REMSERV, not only b.