Avery Dennison 6035 Programmer Manual Rev.CA 6/01 - Manual (Page 38)

Developing Applications 3-11
Using Both Flash ROMs
To use both flash ROMs, include CONFIG.SYS and RDISK.SYS
in the first flash ROM’s disk image. CONFIG.SYS must contain
a reference to RDISK.SYS. See “RDISK.SYS” in Chapter 7 for
more information.
L o a d i n g D i s k I m a g e s i n t o t h e P r i n t e r
To load the disk image created with ROMDISK into a flash
ROM:
1. Connect one end of a cable (see “Hardware Requirements”
in Chapter 1) to the printer and the other end to the PC.
2. Run the REMSERV on the PC.
3. Run the REMDISK on the printer.
4. On the printer, change to the shared PC drive. Enter the
Flash command at the DOS prompt on the printer. See
“FLASH” in Chapter 7 for more information.
5. At the OK TO PROCEED prompt, enter Y.
6. Set the printer down and wait for the loading procedure to
finish. When “PROGRAM SUCCESSFUL” appears on the
display, press e.
CAUTION
Do Not disturb the printer while loading a
disk image.
7. Repeat steps 4 through 6 for the second flash ROM, if
applicable.
8. Re-boot the printer.