Beisler 1360-4 - Manual (Page 103)

D-34
Programming Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
D.3
Programming
Diagnostics
The DIAGNOSTIC menu contains service functions for testing machine
assemblies and initiators that control them.
1. Select the programming menus:
• Press the ( key
2. Select the DIAGNOSTIC function:
• Press the c key
3. Select the test functions:
NOTE - Diagnostics functions!
These service functions should only be performed as in-
structed by the Service Department of Beisler GmbH or in
cooperation with experienced service personnel mem-
bers.
CAUTION - Damage to the machine!
During these tests, individual machine assemblies or ma-
chine cycles are started. If components are partially or
completely removed, machine components may be dama-
ged.
Perform tests only when the machine is at operating tem-
perature!
F1 SERVICE TESTS
These menus are only accessible after the service code has been
entered and must only be selected as instructed by authorized ser-
vice personnel members.
F2 CLAMP TRANSPORT
These functions are used to check the travel characteristics of the
cross transport.
F1 CLAMP MOTOR STEPS
All positions of the cross transport are approached in sequence.